Operation
7
© Travis Industries
4090202
100-01213_000
Remote Synchronization
The remote control is shipped pre-synchronized to the fireplace. If, however, the remote does not
work with the fireplace, follow the directions below to synchronize the remote to the fireplace.
NOTE
: The fireplace must have power and the transmitter must have batteries to complete this process.
WARNING
: Shut the gas off to the fireplace prior to conducting this process.
1
The “Learn” switch is accessed by removing the remote holder. Inside the junction box behind the
holder you will find the “Learn” switch (see the illustration below).
2
Press the “Learn” button once. The fireplace will beep once.
3
Press the “Mode” button on the remote. The fireplace will beep five times to indicate
synchronization.
Fn
Set
Mode
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAA
AAA
AAA
AAA
AAA
AAA
AAA
AAA
AAA
AAA
AAA
AAA
AAA
AAA
AAA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AAA
AAA
AAA
AAA
AAA
AAA
AAA
AAA
AAA
AAA
AAA
AAA
AAA
AAA
Beep
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AAA
AAA
AAA
AAA
AAA
AA
AA
AA
AA
AA
AAA
AAA
AAA
AAA
AAA
AAA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
Beep, Beep,
Beep, Beep,
Beep
NOTE: Re-setting the Receiver Module
If the receiver module fails to synchronize with the remote after two attempts, you should re-set the
receiver module. To do this, hold down the LEARN button for approximately 10 seconds until the
receiver beeps 3 times. This indicates the receiver has been re-set and can be synchronized using
the instructions above.
