Travel Vision TVA 65, Руководство пользователя

Страница: 9 / 21

Page 9
3.2 Installating
1. Before installing the system, make sure that the place is dry and clean, on which the antenna will be
mounted.
It is important that the closing direction of the antenna should be towards back of the vehicle. In this
position, the wind effect is at the minimum level during the driving of the vehicle when the antenna is
closed.
2. Depending on the requirements; two different motor unit installation method can be used.
a. Fixing with bold; align the dish holes with rivets on the mounting bracket and place the dish
onto the mounting bracket. Screw forepart of the dish to mounting bracket with M6x10 screws.
Use silicon to isolate the tighten screws.
b. Fixing with bonding: Lead up the mounting surface and motor unit base plate according the
adhesive. Fix the motor unit by bonding it to the mounting surface.
3. Stick the support bracket 50 of 65 cm (depends dish size) from the rear-middle axis of the antenna.
Check this position before confirming the support.
4. Enter the necessary cables through the roof and mount (if desired with mounting cables from the side)
the roof junction box.
a. Mounting hole diameter 18 mm 12-pin connector
b. Mounting hole diameter 13 mm F-Connector