Page
14
6.
Use, search for satellite.
Power on:
Switch the control box (button
6
.) to On (first time operating).
The red LED (
7
) of the control box lights up and after a few seconds the blue illumination of the control panel
lights up as well. The red LED (
7
) on the control box goes out and the system goes into standby mode.
The system is now initiated and ready for use.
Search for satellite:
•
Please ensure that the system always has a clear view. In Europe, all satellites are in an approximate
position in the south.
Depending on your system there are 3 possibilities:
1. Standard LNB with TVA 65
2. Autoskew LNB with TVA 80
3. Autoskew LNB with TVA 80 Premium
Standard LNB with TVA 65
Check in section 5.4 the correct LNB setting for the desired satellite. If necessary, set the LNB of your antenna.
Press the standby button (
12
.) of the control panel. The blue back light on the control panel lights up and the
antenna moves up.
The antenna searches for the last selected satellite, also displayed on the control panel by a slow blinking LED
(
13
). The elevation (height) also starts at the position that the satellite was previously located.
Once the TVA 65 has located the satellite, it will optimally align with small steps after checking. To indicate that
the satellite has been located the chosen satellite LED (
13
) flashes quickly.
This process takes about 1 minute. After this optimisation phase, the system is in-line with the satellite.
To indicate that the satellite has been located and aligned, the chosen satellite LED (
13
) lights continuously.
The signal is now fully passed on to the connected satellite receiver and you can watch TV.
Autoskew LNB with TVA 80
Press the standby button (
12
.) of the control panel. The blue back light on the control panel lights up and the
antenna moves up. The antenna searches for the last selected satellite, also displayed on the control panel by a
slow blinking LED (
13
). The elevation (height) also starts at the position that the satellite was previously located.
Once the TVA 80 has located the satellite, it will optimally align with small increments after checking. To indicate
that he satellite has been located the chosen satellite LED (
13
) flashes quickly.
During the optimisation of the satellite, the system checks the optimum position of the LNB by means of
autoskew.
This process takes about 1.5 minutes. After this optimisation phase, the system is in-line with the satellite. To
indicate that the satellite has been located and aligned the chosen satellite LED (
13
) lights continuously.
The signal is now fully passed on to the connected satellite receiver and you can watch TV.
Autoskew LNB with TVA 80 Premium
Press the standby button (
12
.) of the control panel. The blue back light on the control panel lights up and the
antenna moves up. The antenna searches for the last selected satellite, also displayed on the control panel by a
slow blinking LED (
13
).
By means of the built-in GPS, compass and clinometer the elevation height, location of the satellite and the Skew
settings will be determined and selected.
NB. If the controller on the power button was turned off and has just been turned on, it takes longer before the
GPS location and the position of the satellite will be determined.
Once the Travel Vision TVA 80 PREMIUM has located the desired satellite, it will optimally align with small
increments after checking. To indicate that the satellite has been located, the chosen satellite LED (
13
) flashes
quickly. This procedure takes about 30 seconds. After this optimisation phase, the system is in-line with the
satellite.To indicate that the satellite has been located and aligned the chosen satellite LED (
13
) lights
continuously.The signal is now fully passed on to the connected satellite receiver and you can watch TV.
Содержание TVA 65
Страница 20: ...Page 20 11 Foorprint TVA systems...
