R O B O G U A R D - U S E R M A N U A L
4
4
4
4
E)
Replace the outer lens and carefully replace the Fastener Ring and Peak.
Be sure that the Outer lens fits into the slots in the Fastener Ring and
Peak, and does not become pinched.
Fig 2
: 11 sets of beams covering an arc of 110°
Fig 3:
Blocking off sections of the main lens.
This image shows 2 windows being blocked off
to allow an arc of 90° to remain.
4. On-Board Computer Configuration.
The Roboguard sensor has an on-board computer that can be configured to perform
optimally in different settings and under specific conditions. There are 5 operation
modes and 3 beam strength settings. These can be adjusted by moving switches
located on the computer board behind each sensor.
To adjust the mode you need to take out the bottom sensor.
To adjust the beam strength you need to take out the top and the bottom sensor.
You will need a small screwdriver