R O B O G U A R D - U S E R M A N U A L
2
2
2
2
1. Roboguard Installation
It is important to take some time to set up your system properly to optimize its
efficiency and to ensure long term peace of mind.
A)
Choose a detection Zone for each of your Roboguard Sensors. Choose a
suitable location on your property that allows the Roboguard an
unobstructed view of the area to be monitored, and is within radio signal
distance from the HQ. (Should there be some doubt about the signal
strength, install the Roboguard per the following instructions and allow
the receiver to notify you if there is a problem.) Ensure there are no
sprinklers aimed at the guard.
B)
Connect each Roboguard to the HQ by assigning it a detection zone
number (see your Receiver user manual).
C)
Remove the cover screw with the Allan key supplied and remove the
battery cover from the Roboguard.
D)
Position the base of the Roboguard at least 80 cm off the ground.
E)
There are 4 mounting spaces provided in the back of the unit. 2 above
the battery rack and 2 below.
F)
Drill 2 (or 4) mounting holes in the unit and corresponding holes on the
mounting surface and attach it to the mounting surface with screws.
G)
Before replacing the cover ensure that each of the 2 sensors is still
correctly positioned, with the mounting screw over the middle line of the
adjustment slot. (
see
Fig 1
) (They sometimes can move during shipping
or during the mounting process)
H)
Your Roboguard is now fully operational.
Note: If you are unsure about the exact location that will be suitable for the
Roboguard you should temporarily mount it to a suitable pole and experiment by
moving it from place to place until you are satisfied with its performance. Then make
the permanent mounting and any other adjustments.
Fig 1
: Sensor mounting screw in the centre of the adjustment slot.