I
nstallation des TR-WMX-3.5
7
1.4.2 Installing the Indoor Unit
The following procedure describes how to install the TR-WMX-3.5 Indoor Subscriber
Unit. Abbildung 1-7 shows the steps for installing the indoor unit.
1.
Connect the supplied antenna to the antenna connector on the rear of the unit.
Facing the rear of the unit, this is the round connector on the right that is
designated with the following symbol:
2.
The TR-WMX-3.5 Indoor Subscriber Unit can be powered by connecting to either an
Ethernet network or an AC outlet. Perform one of the following steps to provide
power the unit:
Connect an Ethernet cable to the RJ-45 jack labeled LAN on the rear panel.
Connect the round end of the supplied power cable to the power connector labeled PWR
on the rear panel. Connect the other end of the cable to a working AC outlet. If
appropriate for your area, use one of the supplied adapters to connect to the AC outlet.
3.
Use the signal LEDs on the top panel of the unit to determine signal strength (see
Table 1-5 on page 22). If signal strength is poor, relocate the unit to try and improve
signal strength, as indicated by the status LEDs on the top panel.
Figure 1-4. Installing the Indoor Unit
n
o
o
p
