14
Step 7. M u t e s w i t c h
Incorporated in the handheld end cap is a Power On
LED and Audio Mute switch. To mute the audio, flick the
switch towards the LED.
Turn on Audio Mute swithch, Power On LED blinks.
Turn on Power Switch with audio muting, after
Power On LED lights for 30 sec, starts blinking.
9. BELTPACK TRANSMITTER SET-UP
Step 1. B a t t e r y f i t t i n g
Open the battery compartment by sliding the
door forward and up. Insert a battery
observing the correct polarity as shown. The
door is marked with a “B”.
Step 2. A n t e n n a f i t t i n g
Screw the antenna into the antenna bush.
Step 3. M i c r o p h o n e
Plug a mic into the Mini-XLR socket.
Step 4. S w i t c h o n
Flick the On/Off switch to the “On” position
and observe the display is on and the
battery LED illuminated. Check the display
indicates the same channel as the receiver.
Step 5. C h e c k f o r r e c e i v e d s i g n a l
Check that the display indicates the same
channel as the receiver. The receiver should
now show a received signal on its RF bar
graphs and after 20 seconds the transmitter
battery status.
Step 6. F r e q u e n c y a d j u s t m e n t
Turn on the transmitter and adjust the
frequency whilst the “decimal point” is flashing (approx. 6 secs) via the “Up” or “Down” buttons. When
the correct frequency is selected, turn the transmitter off then on again to activate the newly selected
channel.
Step 7. G a i n a d j u s t m e n t
Turn on the transmitter and wait for the flashing “decimal point” on the LCD to stop flashing. Press the
“Up” or “Down” buttons to increase or decrease the AF gain. The display will show 0 -9, with “0” gain
being for minimum.
10. BATTERY INDICATON
When the battery capacity in the corresponding transmitter becomes low, the display of the LCD on the
receiver and the transmitter indicate the transmitter’s remaining battery capacity. Replace the transmitter
battery.
Transmitter
Receiver
Transmitter
Receiver
Transmitter
Receiver
Battery capacity is full.
Battery capacity depletion has
started.
Battery capacity is almost
depleted, and battery
replacement is required.
Power
lamp
Mute
switch
