2. After the measurement, the data
transmission starts. The symbol
will blink on the LCD.
If successful,
the symbol will
disappear and the LCD will display
“ ”.
Press the “START/STOP” button to
turn off the device, otherwise it will
power off automatically after about
1 minute.
If unsuccessful,
an error message
(”E5” or “E6” for example) will display
on the LCD for about 1 minute and
then the device will power off.
Note
In the case of a data transmission
failure (E5 or E6), up to 60
measurements are saved on the
device and will be sent when a
successful connection is achieved.
Tip
You can press the “START/ STOP”
button to stop the measurement any time.
1.When the monitor is off, press the “START/STOP”
button to turn on, and then it will complete the whole
measurement automatically.
Adjust the zero point
Taking a Measurement
LCD display
Inflating and measuring
Display the measured result
Take the measurement in a silent room.
Be relaxed, Remain still and DO NOT talk while taking a measurement.
For a meaningful comparison, try to measure under similar conditions. For
example, take daily measurements at approximately the same time, on the
same arm, or as directed by a physician.
Rest for 5 minutes before a measurement.
Helpful tips to help ensure an accurate reading
Start a measurement
12
13
MEASUREMENT
MEASUREMENT