Transtech AERO 130, Руководство оператора

Страница: 27 / 46

Release 3.0 PAGE 27
Setup
Aero 60/90/130
4.4.8 Extra Output 1
Output Y0 turns on at the beginning of the 1
st
print and turns off at the completion of
the 1st print. The pad will then go down to print the 2
nd
image (without picking up a
new image) after the rising edge of input X2. Input X2 can be connected via diodes to
auto switches in parallel to monitor slide/rotary fixture position. For example, position
slide to print the 1
st
image on one side of the part and then print the 2
nd
image on the
other side of the part with only one image pickup and one foot switch activation.
Typically used with two small images and two printing pads.
Output Y0 turns on at the beginning of the 1
st
print and turns off at the start of the 2
nd
print. The printer will initiate its own 2
nd
print. Input X2 can be connected via diodes to
auto switches in parallel to monitor slide/rotary fixture position. For example, position
slide to print the image on one section of the part and then pick up and print the same
image of a 2
nd
section of the part with one foot switch activation. Typically used with
one large image and one printing pad
Output Y0 turns on at the beginning of the cycle every other cycle for the entire print
cycle. Input X2 must be on to allow the printer to finish the cycle. For example,
Pneumatic rotary dial table that goes changes directions with a 2 position single valve.
Input X2 can be connected via diodes to auto switches in parallel to monitor table
position.
Output Y0 turns on at the beginning of the cycle and then turns off at the rising edge of
input X2. For example, electric rotary indexing dial.
Select this to turn on or off the Y0 output mode. When selected to on,
the Y0 will operate to the mode selection. When selected to off the Y0
output will not operate and the printer will run without the mode
selection.
Touch Main Button to jump back to the MAIN screen
Touch arrow button to jump to the previous screen