1800 816 277
www.tti.com.au
9
Product HandBook
FireGuard
™
Filling the Tank
The FireGuard tank is filled as follows:
WARNING! The FireGuard unit is designed for water use only. It must not be
used for chemicals or fuel.
1. Open the tank’s filler cap by twisting and lifting the cap from the tank’s top opening.
2. Insert a hose from the water supply, the at the water supply’s valve, move it to the OPEN position, to allow
water to flow into the FireGuard’s tank.
CAUTION! To prevent overflow, do not leave the filling operation
unattended.
3. Observe the water level directly in the tank. When the tank is filled, move the water supply’s valve to its
CLOSED position.
4. Upon completion of filling, replace the tank’s filler cap.
Pump Operation Procedure
The FireGuard’s petrol pump engine is started as follows, refer to Figure 4:
1. Turn the fuel lever to ON.
2. If the engine is cold, turn the choke lever to ON.
NOTE! Ensure the engine’s throttle is set to idle if the engine is cold. Do not
adjust the throttle to maximum speed until the engine has warmed up.
3. Set the throttle lever to idle for cold starting. If restarting a warm engine, the throttle can be left at normal
engine operating speed.
4. Turn the power switch to ON. Pull the recoil starter handle until the engine starts, then back off the choke
lever to OFF.
5. Once the engine is warmed up, adjust the throttle to increase the engine speed to normal operating revs.
6. When the engine needs to be stopped, turn the power switch to the OFF position.
If the FireGuard is not going to be used within the next few hours, shut the system down by turning the fuel
tap to OFF.
