1800 816 277
www.tti.com.au
8
Product HandBook
FireGuard
™
3. Read and thoroughly understand this handbook, paying particular attention to all safety requirements,
before using the FireGuard for the first time.
4. Check that all fittings and hoses are secure following transit, and are not damaged in any way.
5. Inspect the tank for any damage or abrasions.
CAUTION! The unit must be securely mounted to the vehicle. Failure to do
so may result in the unit moving or falling off the moving vehicle. Warranty
is conditional on the unit being correctly mounted.
6. Position your FireGuard onto the vehicle and mount securely to the tray. If using tie-down straps, they
must be rated to at least the total mass of the unit when filled with water. There is one tie-down recess
across the 220L FireGuard tank (refer to Figure 1), with two recesses for the 400L FireGuard (Figure 2).
Alternatively, the tank incorporates the Surefit pin mount holes on its base, to enable a bolt and bracket
system to secure the unit to the vehicle or optional frame. The 400L unit has four Surefit mount points, the
22L unit has two, refer to Figure 3.
Figure 3 – Surefit Pin Mount System
CAUTION! The engine must be inspected and prepared in accordance with
the manufacturer. Failure to fulfil this requirement may void the engine’s
warranty.
7. Prepare the pump engine in accordance with the Honda manual supplied with your FireGuard unit. Fill the
fuel tank with fresh unleaded petrol.
