TransTank FireBoss, Руководство оператора

Страница: 9 / 20

1800 816 277 www.tti.com.au
9
FireBoss
™
Product HandBook
• Position your FireBoss onto the vehicle and mount securely, either using tie-down straps located into
the tie-down recesses or lugs on both sides of the tank, depending on configuration, refer to Figure 2
and Figure 3 for locations. The tie-down straps must be rated to at least the total mass of the unit when
filled with fluid. Alternatively, the integrated tank frame may be bolted to the vehicle.
• Prepare the pump engine in accordance with the Honda engine’s manual supplied with your FireBoss
unit.
Pump Operation
The FireBoss’s petrol pump engine is started as follows, refer to Figure 3:
• Turn the fuel lever to ON.
• If the engine is cold, turn the choke lever to ON.
• Set the throttle lever to idle for cold starting. If restarting a warm engine, the throttle can be left at
normal engine operating speed.
• Turn the power switch to ON. Pull the recoil starter handle until the engine starts, then back off the
choke lever to OFF.
• Once the engine is warmed up, adjust the throttle to increase the engine speed to normal operating
revs.
• When the engine needs to be stopped, turn the power switch to the OFF position.
CAUTION: The FireBoss must be securely mounted to the vehicle. Failure to do
so may result in the unit moving or falling off the moving vehicle. Warranty is
conditional on the unit being correctly mounted.
CAUTION: The engine must be inspected and prepared in accordance with the
manufacturer’s instructions. Failure to fulfil this requirement may void the engine’s
warranty.
CAUTION: Ensure the engine’s throttle is set to idle if the engine is cold. Do not
adjust the throttle to maximum speed until the engine has warmed up.