TERMINAL ASSIGNMENTS
Test input
at 0V
GND
max.
0,5A/48VDC
PWR
1-5/16”
2-7/8”
ø 1/8”
Rubber grommet
or
Cable gland
M12x1,5
optional cable entry
7/16”
FINE ADJUSTMENT
Hole spacing
LED lights up:
100 % of the cone of light is
hitting the reflector
LED flashing:
L ess than 100 % of the cone
of light is hitting the reflector
ACCESSORIES
SIZE
NOTE: For test purposes the photo-electric switch switches the
transmitter off when GND is applied to ter minal 1. For reasons of
safety the photo-electric switch is responsive to brightness, so that
the relay picks up when the light beam is uninterrupted.
NOTE: The cable entry is
moulded into the lower
part of the casing and
can be broken out.
Either the rubber
grommet or the cable
gland (both supplied)
can be used.
After mounting the photo-switch the light beam can be
adjusted using 3 screws.
IMPORTANT NOTE!
The optical sensor is spring-mounted. All 3 screws are
unscrewed by 1 turn factory-made, the maximum is 3
turns. The optical sensor is optimally aligned when the
green LED lights up constantly.
RAIN COVER FOR THE REFLECTOR.
protection against rain, hail and snow,
impact resistant, UV-stable
material: PA6 GF15
RAIN COVER FOR THE PHOTO-EYE
protection against rain, hail and snow,
impact resistant, UV -stable
material: PA6 GF15
WARRANTY
The warranty period of this product is 24 months, beginning from the
manufacturing date. During this period, if the product does not operate
correctly, due to a defective component, the product will be repaired or
replaced at the sole discretion of Transmitter Solutions. This warranty does not
extend to the product casing which can be damaged by conditions outside of
the control of Transmitter Solutions.
