Transmitter Solutions GSM RECEIVER, Инструкция по установке и эксплуатации

Страница: 3 / 20

1
2
3
4
5
6
7
8
9
LED STATUS
ON
ON
Slow blinking
OFF
LED GSM ON
OFF
ON
ON
ON
BUZZ
OFF
Beep booting
Beep booting
Beep booting
STATUS
No SIM card
No MASTER
PASWORD 0000
Configured
INDICATIONS
The receiver has visual and acoustic signs to indicate its status.
COMPONENTS
1. ON Led
2. Status/Reset/GSM ON
and RUN LEDs
3. SIM Card slot
4. Rel s / TX RX ay LEDs
5. PROG. button
6. Terminal strip
7. Buzzer
8. 12-24 VAC/DC
9. Protection Fuse
INSTALLATION AND WIRING
• The case is fixed to the wall with three external screws.
• Make three holes in the wall using the supplied screws and wall plugs.
• Cut the cable glands located at the bottom of the case for the cables to the GSM’s board.
• Connect the power supply, motor and device cables in the terminals of the terminal strip.
• Activate the power supply and the ON Led will switch on. See fig. 1-1.
12-24 VAC/DC
RESETTING THE GSM PASSWORD
Be sure to update the GSM to at least firmware 0.8. The GSM is able to reset its
password back to 0000 using the PROG button.
1. Power off the GSM
2. Press and hold the PROG button
3. Power on the receiver and wait 8 seconds while holding the PROG button.
The RUN LED will illuminate
4. Release the PROG for two seconds
5. Press and hold the PROG until the GSM beeps three times
6. Release the PROG button
7. The password for the GSM is now 0000