Transmitter Solutions DOLKSS1KB, Руководство по программированию и установке, Страница: 7 / 32

A) Enter Programming Mode with Master Code (Exit-Factory Master Code: 0 0 0 0)
Entry of Master Code Confirm Comments
 
Set system to Programming Mode
NOTE: Factory has put a master code

into the keypad before exit-factory, owner may take it
for first �me use.
B) System Refreshing – Installer Programming (Default: 8 9 0 1, Mul�-user mode)
Refresh Code Confirm Comments
 
C) Code Entries – User Programming
1) Recording Master Code and User Codes – User Programming (No Default Codes)
Loca�ons User IDs Entry of Codes Confirm Comments

4 to 8 digits

Owner’s Master Code for se�ng system to
programming mode

00 to 99 4 to 8 digits

100 User Codes for opera�ng Output 1(Door Lock)
2) Recording Super User Code –
User Programming
(No Default Codes)
Loca�on Entry of Code Confirm Comments

4 to 8 digits

Owner’s Mul�-task User Code
3) Recording the Visitor Codes – User Programming (No Default Codes)
Loca�on User IDs Opera�onTime Entry of Code Confirm Comments

0 to 9 00 to 99 4 to 8 digits

D) Configura�on of Output Modes –
Installer Programming
(Default: Momentary, 1-second)
Loca�on Code of Timing Confirm Comments

1 to 999



STANDARD PROGRAMMING SUMMARY CHART
Output 1, Momentary Mode from 1 to 999 seconds (default=1 second)
Output 1, Start / Stop Mode (toggle)
Output 1, Start / Stop Mode (toggle) with 2-digit Accelerated start code
Output 1, Start / Stop Mode (toggle) with 3-digit Accelerated start code
10 visitor codes for opera�ng Output 1.
Opera�on Time:
00 = One �me use only
01 to 99 = Valid within �me
limit of 1-99 hours
BASIC WIRINGS OF A STAND ALONE DOOR LOCK
NOTE:
Connect the 1N4004 as close as possible to the lock in parallel with the lock power terminals to
absorb the back EMF to prevent it from damaging of the keypad.
To avoid Electro-Sta�c-Discharge from interfering with the opera�on of the keypad, always
ground the (–) GND terminal of the keypad to earth.
The DOOR LED lights up in Green during the door lock is open.
See programming Loca�on 66 for Fail-secure or Fail-safe electric lock se�ng.
●
●
●
●
APPLICATION EXAMPLE
Clear all previously stored data and set keypad back to default values except
Master Code
TAMPER
N.C.
EG
IN
( + ) ( – )
12V DC
( + ) ( – )
DOOR LOCK
ELECTRIC LOCK
12V DC
POWER
SUPPLY
CATHODE
EGRESS BUTTON
1N4004
N.O.
(MORE EGRESS BUTTONS CAN
BE CONNECTED IN PARALLEL)
IMPORTANT NOTE:
See programming Location 66
for Fail-secure or Fail-safe
electric lock setting.
1 2 3 4 5 6 7 8
6 27