Transition TN-USB-FX-01, Руководство пользователя

Страница: 7 / 25

Transition Networks TN-USB-FX-01 User Guide
33589 Rev. D https://www.transition.com/ Page 7 of 25
Connecting the TN-USB-FX-01
This section describes how to connect the TN-USB-FX-01 to a PC/Notebook/PDA. The TN-USB-FX-01 can
be used to connect any device with a USB port to an Ethernet network.
Figure 6: TN-USB-FX-01 Connections
The figure above shows cabling a TN-USB-FX-01 to a laptop PC. The procedure is provided below.
1. Insert the TN-USB-FX-01 USB connector into an available USB port on your computer or device.
Note : For maximum performance, connect the TN-USB-FX-01 directly to a USB 2.0 port on your
computer. If you are connecting to a USB hub, make sure it operates at USB 2.0 speed and can
provide the required power for this device.
2. Insert one end of an Ethernet network cable into the fiber port of the TN-USB-FX-01.
3. Insert the other end of the Ethernet network cable into an Ethernet port on the other end
4. Install the driver; see “ Installing the Driver ” section below.
Driver installation note : After you successfully install the driver, the TN-USB-FX-01 will work properly for
a short while and then stop. Change the “Speed and Duplex Property Value as described in the “ Driver
Configurable Parameters ” section on page 17 .