Transition Networks CGFEB10xx-12x, Руководство пользователя

Страница: 2 / 11

2
CGFEB10xx-12x
24-Hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600
CGFEB1029-120 RJ-45
100 m
(328 ft)
SC, 1310nm TX/1550nm RX single mode
20 km
(12.4 miles)
CGFEB1029-121 RJ-45
100 m
(328 ft)
SC, 1550nm TX/1310nm RX single mode
20 km
(12.4 miles)
Install CGFEB1029-120 and CGFEB1029-121 single-fiber optic in
the same network where one is the local converter and the other is
the remote converter.
CGFEB1029-122
RJ-45
100 m
(328 ft)
SC, 1310nm TX/1550nm RX single mode
40 km
(24.9 miles)
CGFEB1029-123 RJ-45
100 m
(328 ft)
SC, 1550nm TX/1310nm RX single mode
40 km
(24.9 miles)
Install CGFEB1029-122 and CGFEB1029-123 single-fiber optic in
the same network where one is the local converter and the other is
the remote converter.
CGFEB1029-126 RJ-45
100 m
(328 ft)
SC, 1510nm TX/1590nm RX single mode
80 km
(49.6 miles)
CGFEB1029-127 RJ-45
100 m
(328 ft)
SC, 1590nm TX/1510nm RX single mode
80 km
(49.6 miles)
Install CGFEB1029-126 and CGFEB1029-127 single-fiber optic in
the same network where one is the local converter and the other is
the remote converter.
Part Number Port 1 - Copper
10/100/1000Base-T
Port 2 - Duplex Fiber-Optic
1000Base LX
CGFEB10xx-12x
techsupport@transition.com -- Click the “Transition Now” link for a live Web chat.
3
Installation
CAUTION: Wear a grounding device and observe electrostatic discharge precautions
when handling the media converter. Failure to observe this caution could result in
damage or failure of the media converter.
Six-position switch
The six-position switch is located on the circuit board of the media converter. Use a
small, flat-blade screwdriver
(or a similar device) to set the switch according to the
site requirements (see the drawing below) .
TP Speed: UP =100 Mbs, Down = 10 Mbs (Note 1)
TP Auto-Negotiation: UP = Enabled, Down = Disabled
TP Duplex: UP = Full, Down = Half (Note 1)
LPT: UP = Enabled, Down = Disabled
Unused
SW Position Up
SW Position Down
Unused
1 2 3 4 5 6
Note 1:
Only use when Auto-Negotiation is disabled.
1. TP Auto-Negotiation
UP Enable Auto-Negotiation for the copper connection.
DOWN Disable Auto-Negotiation for the copper connection.
2. TP Speed 10Mbs/100Mbs
UP Set copper connection speed to 100Mbs.
DOWN Set copper connection speed to 10Mbs.
3. TP Full/Half Duplex
UP Operate in full-duplex mode.
DOWN Operate in half-duplex mode of the attached device.
4. Link Pass-Through (LPT)
UP Enable Link Pass-Through
DOWN Disable Link Pass-Through.
5. Not used
6. Not used