other. If you are certain that the charge to be neutralized is primarily posi-
tive or negative, you can adjust the bar to produce the opposite charge.
For example, molded plastic components has a large primarily negative
charge so you would increase the positive ions produced by the bar.
You can set the ion bar to only positive or only negative with the "P" and
"N" on the remote. Cycle the bars power off and on to reset this.
Remote Control Operation
"R/S":
Run/Stop: Turns the bar on and off
"IB+":
Increase duty ratio
"IB
-
"
Decrease duty ratio
"P":
Only positive voltage cycle
"N"
Only negative voltage cycle
"Bar":
Adjusts the ion bar working frequency.
"C":
Rest
The bar can be set from 1hz (slowest) to 50hz
(fastest) by pressing "Bar" and then a number:
"Bar"+"1":
Set ion bar working frequency 1Hz;
"Bar"+"2":
Set ion bar working frequency 3Hz
"Bar"+"3":
Set ion bar working frequency 5Hz;
"Bar"+"4":
Set ion bar working frequency 10Hz
"Bar"+"5":
Set ion bar working frequency 20Hz;
"Bar"+"6":
Set ion bar working frequency 30Hz
"Bar"+"7":
Set ion bar working frequency 50Hz; "
High Voltage Alarm
The ion bar will issue an alarm (Alarm 1) on the LED if a HV error occurs.
The error is a result of an issue with the high voltage current flowing
through the bar. If an HV error occurs, turn of the ion bars power and con-
tact Transforming Technologies at 419
-
841
-
9552.
