Transcend ESD200, Руководство пользователя

Страница: 6 / 19

4
Safety Precautions
︱
These usage and safety guidelines are IMPORTANT! Please follow them carefully.
General Use

Carefully unpack the contents of the ESD200 package.

During operation, avoid exposing your ESD200 to extreme temperatures above 70
℃
, or
below 0
℃
.

Do not drop your ESD200.

Do not allow your ESD200 to come in contact with water or any other liquids.

Do not use a damp/wet cloth to wipe or clean the ESD200 exterior case.

Do not store your ESD200 in any of the following environments:
o
Direct sunlight
o
Next to an air conditioner, electric heater or other heat sources
o
In a closed car that is in direct sunlight
o
In an area with strong magnetic fields or excessive vibration

If your Windows computer will not boot while the ESD200 is connected, please
disconnect the ESD200 from your computer first and reconnect the ESD200 after
booting Windows. Otherwise, refer to your computer's manual and change the BIOS
settings to instruct the computer to boot from a different device.
Backing up Data

Transcend does NOT take any responsibility for data loss, or damage during
operation . If you decide to store data on your ESD200 we strongly advise that you
regularly backup the data to a computer, or other storage medium.

To ensure SuperSpeed USB 3.0 data transfer rates when using your ESD200, please
make sure that your computer has the relevant drivers and hardware to support USB 3.0.
If you are unsure about how to check this, please consult the user
’s manual of your
computer, motherboard, or USB 3.0 interface card for USB 3.0 driver information.
Transporting

Do not pack the ESD200 into luggage without proper padded support. Other items in
your luggage may damage the SSD during travel if it does not have proper protection.

Avoid squeezing or compressing the ESD200.

Do not place objects on top of your ESD200.
Power

The ESD200 is powered directly via a computer USB port. However, the power supplied
by the USB port on some older computers is below the 5V DC required to power the
ESD200.

Use only the USB 3.0 cable that came with the ESD200 to connect it to a computer, and
always ensure that the cable you are using is in good condition. NEVER use a cable that
is frayed or damaged.