5
ACCESSING THE MENUS
To access the Setup (“F) menu:
1. Power off the indicator.
2. Locate the slide switch on the rear cover and move it to the opposite position.
NOTE: A metal plate held on by two drilled-head screws may conceal the slide switch.
3. Power on the indicator.
The display shows ” F 1” to indicate that you are in Setup Menu mode.
4. Use the navigation keys shown in the figure below to move through the menu.
To access the User (“A) menu:
1. Enter the Setup (“F”) menu.
2. Use the right or left directional keys shown below to move right or left in the Setup (“F”) menu
until the indicator shows ” A 1”.
SETUP MODE KEY FUNCTIONS
ZERO
GROSS
NET
TARE
SET
UNITS
MENU STRUCTURE
All menus consist of a top level (heading) and a secondary level. The top level contains the code (e.g.
F1) for the parameter to be configured. The secondary level contains the selection list or allows access
to a programming sequence.
Use the directional keys to move around in the Menu Structure shown below.
F1
Grads
10
80
F2
Sampling
Numeric Entry
Etc.
1.
To move to a new heading, use the TARE (left) or PRINT (right) key to move right or
left in the Menu.
2.
To move to the selection or programming level, press the ZERO (down) key once.
The currently saved selection is shown.
3.
To view the available selections for the current heading, use the TARE (left) or
PRINT (right) key to move through the selection field.
4.
To save a new selection, press the NET/GROSS (Set) key .To exit without saving,
press the UNITS (up) key to return to the current heading.
5.
Repeat Steps 2 through 5 until the Menu is programmed.
