TransAct AccuDate XL, Быстрый старт

Страница: 9 / 20

7
6. Now load labels into the device.
a. Grab hold of the two tabs at either side of the
lower section of the display and pull up. The
hinged display will make a click sound and you will
be able to swivel the display up until it is parallel
with your tabletop.
The two label printer mechanisms and label
buckets will be visible. The AccuDate XL uses
thermal printing technology so no ink or toner is
required.
b. Open each printer mechanism by pushing the
blue tab on the left side of each mechanism to the
left. The top of the printer mechanism will open.
c. Both of the mechanisms can handle narrow and
wide labels. In this example, place the roll of 2.2”
x 2” labels into the left printer label bucket and
then the 1.2” x 1” labels into the right printer label
bucket. Make sure the labels feed from the top.
Note: Your label style and size may differ.
Note: If unpacking the labels has resulted in any of the
leading labels being pulled off the roll, leaving a blank
space, trim the roll to eliminate the gap. Otherwise the
gap from a missing label can cause your printer to stop
printing requiring you to re-set the label roll.
d. Next, thread the labels
under the label sensor as
shown to the right. Notice
that the 1.2” wide labels
will slide only part of the
way under the sensor
because they need to
remain centered with
the roll, while the 2.2”
wide labels will slide all
the way under the label
sensor to the left edge.
e. Then close the latch of the printer mechanisms.
There will be some movement of the labels after you
close the latch and the labels align for printing.
f. Now you are ready to close the display.
Rotate the hinged display down until
it clicks to its closed position.