Command Set Summary
Trango Broadband Wireless — TrangoLINK-10 User Manual Rev. E 3.0
page 26
Appendix A Command Set Summary
•
OFF = Opmode “OFF,” ON = Opmode “ON”
•
s = serial, e = Ethernet
•
+ It may not work properly through HTTP’s command console.
Command Description
OFF
ON
Remark
!+
redo the last command
s
s
?
same as “
help
” se
se
? <command>
same as “
help
” se
se
_password <new password>
<new password>
specify new password (max 15octs)
se
se
arp –bcast [<on | off>]
enables/disables the sending of periodic arp
broadcast packets to gateway
se se
baud [<9600 | 115200>]
display or set console baud rate
se
se
default = 9600 bps
bye
same as “
logout
” se
se
eth <link | r | w | reset>
display or set Ethernet setting
se
se
exit
same as “
logout
” se
se
freq
display current channel
se
se
freq <ch#> <h | v>
change current channel and polarization
se
se
freq channeltable
display channel table
se
se
freq writechannel [<ch #>
<freq>]…
build channel and write to flash
<ch #> = 1..30
se se
heater [<on temp, 0..19> <off
temp, 1..20>]
set heater parameters
se
se
help
display complete help page except “eng”
se
se
help <command>
search and display command’s help
se
se
ipconfig [<new ip> <new subnet
mask> <new gateway>]+
assign radio’s IP, subnet mask, and
gateway IP
se se
logout logout
of
console se
se
maclist macexp <30..600>
change expiration time of MAC entry in
maclist
se
se
AP’s default is 600s
SU’s default is 30s
maclist filter [<on | off>]
filter out all local Ethernet packets
se
se
default: on
maclist [<reset>]
display or reset current MAC table
se
se
msearch <sec> <ch#>
<h | v>…
Master search – RU will search for MU on
specified channel and polarization.
se
opmode [<on | off>]
set or display current Opmode
se
se
password
specify new password (max 15octs)
s
s
ping <ip address>
ping local Ethernet device
se
se
It only works for local
Ethernet devices, not
SU or any device behind
SU.
power
display default and current TX power level
se
se
default = +18 dBm
power <setism>
<min | max | dBm>
specify TX power for both band
se
se
SU’s power will be
adjusted by MU when
association
ru ipconfig <new ip> <new
subnet> <new gateway>
assign Remote
ipconfig
se
ru ping
ping Remote Radio
se
ru powerleveling
power levels RU to reach Target RSSI, set
in MU
se
