Literature Change
History
UHEC-IM-7 (September 1992)
Original issue of manual covering “C”
design sequence units.
EUH-IM-7A (August 1995)
Revision of electrical data and
addition of accessory fan guard.
UHEC-IM-7A (February 1997)
Manual revised to include literature
name change to reflect model
number, addition of junction box
volume table and addition of
anemostat diffuser.
Warnings and Cautions
Warnings and cautions appear at
appropriate intervals throughout this
manual. Your personal safety and the
proper operation of this machine
require that you follow them carefully.
The Trane Company assumes no
liability for installations or servicing
performed by unqualified personnel.
Warnings alert the equipment
rigger, owner/operator and service
personnel to potential hazards that
could result in personal injury or
death.
Cautions are provided to alert
personnel to conditions that may
result in equipment or property
damage.
For your convenience, typical unit
wiring diagrams are provided at the
end of this booklet.
Unit Inspection
When the unit is delivered to the job
site, verify that the correct unit has
been shipped by comparing the
information on the unit nameplate
without ordering, submittal and
shipping information.
Inspect the unit — including its internal
components— for damage. Rotate the
fan to ensure that it turns freely.
Report any apparent damage or
material shortage to the carrier and
make a “unit damage or shortage”
notation on the carrier’s delivery
receipt. Specify the extent and type of
damage found and notify the
appropriate Trane sales office. Do not
proceed with installation of a damaged
unit without sales office approval.
General
Information
4
UHEC-IM-7A
