Trane UHAA-02, Установка, эксплуатация и обслуживание

Страница: 8 / 16

8 UHAA-IOM-1E
Installation Instructions
Before Mounting
1. Insure that supply voltage matches voltage rating on heater label.
2. Turn off electrical power to heater circuit.
Mounting Instructions
You can either flush-mount or surface-mount the heater by performing the following steps:
1. Disassemble heater by removing seven screws shown as "C" in Figure 2 and 3.
2. Complete one of the following sequences according to Figure 2 or
To Flush-Mount Heater:
1. Place wall box "A" between studs at desired height
2. Secure to studs through holes "M" in box.
The flanges on the wall box must rest on the surface of the finished wall. Be sure to allow for
wall thickness.
Figure 2. Flush-Mounting Heater Into Wall
WARNING
Hazardous Voltage!
Disconnect all electric power, including remote disconnects before servicing. Follow proper
lockout/tagout procedures to ensure the power can not be inadvertently energized. Failure to
disconnect power before servicing could result in death or serious injury.