3
1
2
SAFETY WARNING
Only qualified personnel should install and service the equipment. The installation,
starting up, and servicing of heating, ventilating, and air-conditioning equipment
can be hazardous and requires specific knowledge and training. Improperly
installed, adjusted or altered equipment by an unqualified person could result in
death or serious injury. When working on the equipment, observe all precautions in
the literature and on the tags, stickers, and labels that are attached to the
equipment.
© 2020 Trane
Order Number: BMSC000AAA01100
Warnings, Cautions, and Notices
Read this manual thoroughly before operating or servicing this unit.
Safety advisories appear throughout this manual as required. Your
personal safety and the proper operation of this machine depend upon
the strict observance of these precautions.
Packaged Contents
Required Tools
• 5/16 in. (8 mm) slotted screwdriver
• 1/8 in. (3 mm) slotted screwdriver
The three types of advisories are defined as follows:
WARNING
Indicates a potentially hazardous situation
which, if not avoided, could result in death or
serious injury.
CAUTION
Indicates a potentially hazardous situation
which, if not avoided, could result in minor or
moderate injury. It could also be used to alert
NOTICE
Indicates a situation that could result in
equipment or property-damage only accidents.
One (1) Tracer SC module
(controller)
One (1) Power supply module (PM014)
Two (2) 4-position terminal block
plugs
Six (6) 3 position terminal block plugs
One (1) LON termination kit
Two (2) 2 position terminal block plugs
One (1) Installation sheet
One (1) IMC power cable 3 in. (75 mm)
long
One (1) phone cable
Mounting and Removing the Tracer SC and the
Power Supply Module
• The mounting location must meet the temperature and humidity
specifications as outlined in
Table 1
.
• Do not mount on a flat surface, such as on a floor or on top of a table.
Mount in an upright position with the front facing outward.
To mount the Tracer SC or the power supply module:
1. Hook the top half of the Tracer SC onto the DIN rail.
2. Gently push on the lower half of the Tracer SC until the release clip
snaps into place.
3. Hook the top half of the power supply module onto the DIN rail next
to the Tracer SC.
4. Gently push lower half of power supply module until the release clip
snaps into place.
WARNING
Hazardous Voltage!
Disconnect all electrical power, including remote disconnects, before
servicing. Follow proper lockout/tagout procedures to ensure the power
cannot be inadvertently energized. Failure to disconnect power before
service could result in death or serious injury.
snap
Mounting the Tracer SC
(or the power supply
module)
Removing or Repositioning the Tracer SC or the
Power Supply Module
To remove or reposition the Tracer SC or the power supply module:
1. Insert a screwdriver into the slotted release clip and gently pry
upward on the clip with the screwdriver,
OR;
If the screwdriver fits the slot size, insert the screwdriver into the
slotted release clip and rotate it to the left or right to release tension
on the clip.
2. While holding tension on the slotted release clip, lift the Tracer SC (or
power supply module) upward to remove or reposition.
3. If repositioning, push on the Tracer SC (or power supply module) until
the slotted release clip snaps back into place.
Removin
g the
Tracer SC
December 2020
BAS-SVN215J-EN
Installation Instructions
Tracer
®
SC System Controller
with PM014 Supply Module
X3641154-01
