3
3270 3403 D
Frame-mounted Tracer™ AH541 Controller
Installing the Termination Board
To install the termination board:
1.
Remove the controller from its packaging and separate the top and bottom frames.
2. Using the bottom frame (with the termination board) as a template, mark the location of the four mounting holes and
the grounding screw on the mounting surface.
3. Set aside the controller and then drill holes for #8 (4 mm) screws at the marked locations.
4. Drill a 1/8 inch diameter pilot hole for the supplied grounding screw.
5. Secure the controller to the mounting surface with the enclosed using #8 (4 mm) screws (not supplied) in the mounting
holes.
Figure 2.
Dimensions and mounting holes
Mounting hole
(4x)
Grounding screws
location
