TK 55676-19-IM-EN
53
HMI Installation
HMI Location
•
Choose a location inside the tractor’s sleeper for the HMI controller that is easily accessible and visible from the
drivers bunk.
•
The HMI should be visible and mounted away from windows, air vents, out of direct sunlight to accurately measure
air temperature.
Installation Procedures
Special Tools Required
Level
Drill Motor
Drill Bits
Locate the H
HM
MII C
Co
on
nttrro
olllle
err H
Ha
arrn
ne
essss with the 8
8--p
piin
n connectors on each end supplied loose in the installation kit.
1. Connect one 8-pin harness connector to the HMI ((J
J3
34
4)) connector on the main controller board inside the control
box.
2. From the control box, route the harness behind the interior walls (if applicable) to the location chosen to install the
HMI controller.
3. Unsnap the rear mounting base from the controller and route the 8-pin harness connector through the access hole.
•
Position and level the mounting base and install securely.
4. Push the connector firmly into the rear of the controller and snap the controller back onto the mounting base.
D
DP
PF
F U
Un
niittss O
On
nlly
y -- E
Ex
xh
ha
au
usstt M
Mo
on
niitto
orr a
an
nd
d R
Re
eg
ge
en
ne
erra
attiio
on
n S
Sw
wiittcch
h
Install the exhaust monitor and regeneration switch now. Refer to TK 55727-19-IM for details.