Trane 4TXK6512G1000AA, Руководство по обслуживанию

Страница: 76 / 187

Caution
Cautions for the installation personnel
Don’t fail to show customers how to operate unit .
BEFORE INSTALLATION <Don’t discard any accessories until comp>

Determine the way to carry unit to installation place .

Don’t remove packing until unit reaches installation place .

If unpacking is unkavoidable, protect unit properly .
SELECTION OF INSTALLATION PLACE
(1) Installation place shall meet the following and agreed by customers:

Place where proper air flow can be ensured .

No block to air flow .

Water drainage is smpoth .

Place strong enough to support unit weight .

Place where inclination is not evident on ceiling .

Enough space for mainenance .

Indoor and outdoor unit piping length is within limit . (Refer to Installation Manual for outdoor unit .)

Indoor and outdoor unit, power cable, inter unit cable are at least 1 m away fromT .V . radop . This is helpful
to avoid picture disturbance and noise . (Even if 1 m iskept, noise can still appear if radio wave is strong)
(2) Ceiling height
Indoor unit can be installed on ceiling of 2 .5-3m in height . (Refer to Foeld setting and Installation Manual of
ornament panel .)
(3) Install suspending bolt .
Check if the installation place is strong enough to hold weight . Take necessary measures in case it is not safe .
(Distance between holes are marked on paper pattern . Refer to paper pattern for place need be reinforced)
6 1
Unit shall be grounded. But grounding shall not be connected to gas pipe water pipe, telephone line. Poor
grounding

will cause electric shock.

Be sure to install a leakage breaker to avoid electric shock.

Arrange water drainage according to this Manual. Cover pipe with insulation materials in case dew may
occur. Unproper installation of water drainage will cause water leakage and wer your furniture.

To maintain good picture or reduce noise, keep at least 1 m from T.V. radio, when install indoor and outdoor
unit, connecting wire and power line. (If the radio wave is relatively strong, 1 m is not enough to reduce noise).

Don’t install unit in following places:
(a) Oil mist or oil gas exists, such as kitchen, or, plastic parts may got aged, or water leakage.
(b) Where there is corrosive gas. Copper tube and welded part may be damaged due to
corrosion, causing leakage.
(c) Where there is strong radiation. This will affect unit’s control system, causing malfunction of the
unit
(d) Where flamable gas, dirt, and volatile matter (thinner, gasoline) exist, These matter might cause fire
accident.

Refer to paper pattern when installing unit.