Trane
6200 Troup Highway
Tyler, TX 75707
www.trane.com
For more information contact
your local dealer (distributor)
The manufacturer has a policy of continuous product and product data improvement, and it reserves the right
to change design and specifications without notice.
SUPPLEMENTARY HEATERS CHECKOUT PROCEDURES,
IF USED DOES HEATER REQUIRE A SPECIAL CIRCUIT?
SEE “LIMITATIONS AND RECOMMENDATIONS”
1. Be sure the disconnect switch is “OFF”, and safety label (if any) is attached ....................................... [ ]
2. Check on field wiring for tight connections and grounding according to codes ..................................... [ ]
3. Check circuit protection for proper size per nameplate specifications ................................................... [ ]
4. Check control box panel — in place and secured..................................................................................... [ ]
NOTE: OPERATION OF HEATERS MUST BE CHECKED DURING THE OPERATION CHECK OF THE TOTAL
SYSTEM.
CHECKOUT PROCEDURES
After installation has been completed, it is recommended that the Air Handler be checked against the following
checklist.
1. Make sure power is “OFF” at power
disconnect switch ................................................. [ ]
2. Check all field wiring for tight connections. See
that grounding of unit is in accord with code .... [ ]
3. Make sure unit suspension (if used) is secure
and that there are no tools or loose debris in,
around or on top of the unit ................................ [ ]
4. Check all duct outlets; they must be open and
unrestricted ......................................................... [ ]
5. Check drain lines and be sure all joints are tight
.............................................................................. [ ]
6. Make sure secondary drain pan is installed ...... [ ]
7. Check power supply for correct requirements
per unit nameplate .............................................. [ ]
8. Check filters for proper size. Inform owner
of proper procedure for removal and
reinstallation ....................................................... [ ]
9. Energize the system and carefully observe its
operation; make any necessary adjustment ....... [ ]
10. Instruct owner, engineer (if possible) on proper
operating procedure and leave Use and Care
Manual with owner ............................................. [ ]
Installer’s Guide
J. CHECKOUT PROCEDURE
1. Check the Air Handler operation and installation
in accordance with these instructions below.
2. “Operational Procedure” for the system instal-
lation can be found in the outdoor unit installer
guide and will be compatible with this Air Han-
dler.
CAUTION
!
Cardboard packing material must be removed from in-
side the blower assembly before starting the unit.
Failure to do so may cause indoor blower motor fail-
ure.
WARNING
!
ELECTRICAL SHOCK WARNING
LOCK OUT UNIT DISCONNECT SWITCH IN OPEN PO-
SITION BEFORE SERVICING UNIT. FAILURE TO FOL-
LOW THIS WARNING COULD RESULT IN PROPERTY
DAMAGE, PERSONAL INJURY, OR DEATH.
The following warning complies with State of California law, Proposition 65.
▲
WARNING:
This product contains
fiberglass wool insulation!
Fiberglass dust and ceramic
fibers are believed by the State of California to cause
cancer through inhalation. Glasswool fibers may also
cause respiratory, skin, or eye irritation.
PRECAUTIONARY MEASURES
●
Avoid breathing fiberglass dust.
●
Use a NIOSH approved dust/mist respirator.
●
Avoid contact with the skin or eyes. Wear long-
sleeved, loose-fitting clothing, gloves, and eye
protection.
●
Wash clothes separately from other clothing: rinse
washer thoroughly.
●
Operations such as sawing, blowing, tear-out, and
spraying may generate fiber concentrations requiring
additional respiratory protection. Use the appropriate
NIOSH approved respirator in these situations.
FIRST AID MEASURES
Eye Contact -
Flush eyes with water to remove dust.
If symptoms persist, seek medical
attention.
Skin Contact -
Wash affected areas gently with soap
and warm water after handling.
