Trance Audio THE AMULET M, Руководство пользователя, Страница: 5 / 20

5
DUAL MONO PREAMP FEATURES
Amulet M
™
The Amulet M utilizes our newly-designed Acoustic Engine ™
technology, providing each transducer with its own extremely low noise
preamp, and providing the ability to easily balance between the two
transducers to get the exact response desired from your instrument.
These signals are combined to a monaural signal, and buffered to
produce a hum and noise-free signal at the endpin jack that’s ready to
plug into any system. This allows you to get the maximum dynamic
range and lowest noise possible from the transducers to produce a clear,
defined sound that easily captures the nuances and dynamics of your
performance.
BUILT-IN LOW CUT FILTER
The Amulet M system includes our high quality low cut filter built into its
circuitry. This filter eliminates any subsonic information below 40 Hz that
might cause noise or distortion in your amplification rig. This filter has
been carefully engineered to leave the low end response of your guitar
intact, even when tuned to far below normal pitch.
ENDPIN JACK
The endpin jack serves as the audio output of the system, the power
on/off switch, and also as the strap button where you can secure the
back of the strap for your instrument. A high-quality Switchcraft jack is
used to insure a long and trouble-free performance. The endpin jack
connects your instrument via a standard
¼ ” MONO guitar cable to your
amplifier, external effects device or mixer. It also serves as the on/off
switch for the system, so be sure to unplug the cable when not in use to
preserve battery life.
NOTE: Use of a STEREO ¼ ” cable (sometimes called a TRS
connector) will not allow the system to properly power up, and
must be avoided.