TEF 2440
LUMINAIRE USER MANUAL
INTRODUCTION
Thank you for purchasing this product!
For installation, maintenance and assurance of a long life
of this product, please follow this manual.
CONTENT IN BOX
The product is fully assembled, and ready for installation.
SAFETY PRECAUTIONS
Note that changes made to the product and/or installation
of components which do not conform to the approval, may
be a safety violation. The manufacturer will in no
circumstance be held responsible for such activity.
For your health and safety, always use safety gear suited
for the task. Be certain to follow codes, regulations and/or
specific procedures that are related to the installation.
TOOLS REQUIRED
Regular tools required for installation.
•
10mm wrench whien installing the luminaire.
•
32mm wrench whien installing the cable gland.
•
30mm wrench when installing the lock nut.
•
25mm wrench when tightening the pressure nut.
•
PZ 2 screwdriver for assemble/dissemble the globe.
•
3 mm straight screwdriver for terminal to connect the
lighting.
•
5 mm straight screwdriver for earth screw.
Do not use powertools when fastening globe!
MAINTENANCE INSTRUCTIONS
The luminaire should be inspected according to Company
routines. The manufacturer suggests regular check for
water intrusion/condensation which should be removed
immediately. Check the drain plug / drain hole function.
When cleaning, use only mild detergents. Alcohol or
petroleum based products may damage lens, paint or
plastic components.
RUBBER SEAL
Cable diameter
Size
Part No.
8,5 - 13,5mm
Ø23/13x8mm
5002 0124
13 - 17mm
Ø23/16x8mm
5002 0125
Be sure to install cable in a way wich prevents water to penetrate into the enclosure through the cable gland,
also make sure to use the correct rubber seal when you install the luminaire.
APPLICATIONS
•
Deck lighting
•
Signal lighting
•
Obstacle marking
•
Perimeter light for helideck landing areas
APPROVALS
NEMKO Certificate No.: 03ATEX3336
