3.4.2. Assembly instructions
STEP 1
Align two M6 screws (item 10) with the holes in the outer holder (item 2) according
to picture 12. Insert the holder with the screws into the bowl (item 6), making sure
that the attachment holes for the legs face the center of the grill as shown in picture
13. Align the inner holder (item 3) while holding the screws and secure the M6 nuts
(item 11). Tighten them well as shown in picture 14. Repeat the same procedure for
the other two sets of holders.
STEP 2
Hold the existing pin on the leg (item 1) and insert it into the securing hole of the
outer holder (item 2) according to picture 15. Make sure that the hole of the outer
holder is facing the inside of the grill structure. Repeat the same procedure for the
other two legs. To assemble the chrome steel triangle (item 8), align the hole of the
outer holder as well as the leg holes properly.
STEP 4
Place the charcoal tray (item 5) on the supports of the three inner holders according
to picture 17. Then place the cooking grate (item 4) on the upper supports of these
same holders as shown in picture 18.
STEP 3
Position the chrome steel triangle (item 8) and secure it with M5 screws (item 9) as
shown in figure 16.
Picture 13
Picture 14
Picture 16
Picture 12
Picture 15
Picture 17
Picture 19
Picture 18
Picture 20
NOTE: The cooking grate (item 4) is double-sided, meaning it can be used on both
of its sides:
• With the channel in a “V” position (picture 19), it reduces flames and results in
closer markings.
• With the channel in a “ ” position (picture 20), it reduces smoke and results in
more spread out markings. Cleaning is easier when the grill is used in this position.
V
10
6
Attachment
hole
3
11
2
2
1
9
8
4
5
10
