7. After initial fire, engine will continue to run, return choke lever slowly to open position.
8. If engine stops after a few fires by procedure (7), return choke lever to open position and pull recoil starter
handle strongly again.
9. If engine does not start by procedure (8), repeat procedures from (5).
10. After starting engine, return throttle lever to idle position for slow engine. Then allow the engine about 2-3
minutes to warm up before use. (Fig. 3-6).
WARNING
• Once engine is started, do not leave tool alone. Always hold handle tightly so that tool will not
move around on the stand or floor.
• Before and during operation, always take a firm stance and keep safety position from slipping or
falling down.
(FIG. 3-4)
PRIMING BULB
OPEN
(FIG. 3-5)
(FIG. 3-6)
CLOSED CHOKE LEVER
(FIG. 3-3)
WARNING
1. Power tools shall not be used in potentially explosive atmospheres unless specially designed
for that purpose.
2. Unexpected tool movement due to reaction forces or breakage of inserted tool may cause injuries.
3. Power tools shall be isolated from the energy source before changing or adjusting the
inserted tools.
4. Avoid the risk of being injured, keep hands away from the nut runner socket.
5. Avoid the danger to persons from high-speed splinters being emitted from impact wrenches
in the case of nut runner socket failure.
6. Unexpected direction of inserted tool movement can cause a hazardous situation.
7. Avoid inhaling the dust and ejected particles when operating the tool.
8. Continued use over prolonged periods of time can injure hands. If hands numb, ache or shows
white skin, operator should stop tool use and immediately seek medical attention.
OPERATING INSTRUCTIONS
6
7
OPERATION
1. Select R (for clockwise direction) or L (counter clockwise direction)
gear for fastening or loosening bolts and nuts.
2. Always release throttle lever to allow slow engine for idling and
turn gear change lever. DO NOT change gear when engine is accelerating.
3. Squeeze throttle lever for high speed to tighten or loosen bolts and nuts
and control engine speed with throttle lever.
4. Once bolts or nuts are fastened, release throttle lever for idling and not
allow driving shaft to turn. Remove socket from bolt of nut.
STOPPING ENGINE
1. Release throttle lever to decrease engine speed.
2. Return stop switch to stop position (Fig. 3-7)
3. Place the tool on firm stand or solid floor and turn gear change lever
to N (neutral) position.
(FIG. 3-7)
