www.TrailFX.com
Page
3
of
7
Rev 031318
b.
Select the driver side front Mounting Bracket,
(Figure 6)
. Attach the Bracket to the threaded end of the Bolt
Plate with (1) 8mm Flat Washer, (1) 8mm Lock Washer and (1) 8mm Hex Nut,
(Figure 7)
. Do not tighten at
this time.
c.
Remove the 8mm Hex Bolt from the nut on the Bolt Plate from
Step 3a
. Rotate the Bolt on the Bolt Plate until the
threaded nut lines up with the remaining hole in the Mounting Bracket and body panel,
(Figures 7 & 8)
. Attach
the Bracket to the threaded Nut Plate with (1) 8mm x 30mm Hex Bolt, (1) 8mm Lock Washer and (1) 8mm Flat
Washer,
(Figure 8)
. Do not fully tighten hardware at this time.
Models with factory threaded inserts:
a.
Attach the driver side Front Bracket to the threaded inserts with (2) 8mm x 30mm Hex Bolts, (2) 8mm Lock
Washers and (2) 8mm Flat Washer,
(Figures 9 & 10)
. Leave hardware loose.
(Fig 6) Driver side front Bracket
Front
(Fig 7) Attach Bracket to Bolt Plate
Front
Remove Hex Bolt, rotate Bolt/Nut Plate
to line up threaded nut with body panel
and Mounting Bracket (see arrow)
8mm Flat Washer
8mm Lock Washer
8mm Hex Nut
Front
(Fig 8) Attach Bracket to threaded end of
Bolt Plate first. Remove 8mm Hex Bolt
(see Fig 3). Rotate Bolt Plate to line up
with remaining factory hex shaped hole.
8mm Hex Bolt
8mm Lock Washer
8mm Flat Washer
Plastic Retainer
Front
(Fig 9) Driver side front mid 2015-on, an example of
models with factory installed threaded inserts
(Fig 10) Driver side front-models with factory
installed threaded inserts. Bolt Plate not required
Front
(2) 8mm Hex Bolts
(2) 8mm Lock Washers
(2) 8mm Flat Washers
