Wiring Loom Fitting Instructions
To Suit Honda CR-V
Part Number 101866-WL
Page
2 of 3
Issue Date
15-02-18
Cequent Customer Service
Ph: 1800 812 017 Fax: 03 9797 3299
Email: [email protected]
Post: PO Box 4050, Dandenong South VIC 3175
1. Disconnect the negative battery terminal.
2. Pull the lever and fold down the rear passenger seats.
3. Remove the two cargo hooks.
4. Remove the luggage compartment front carpet trim.
5. Remove the floor carpet cover.
Note: For 7 seat variant, remove the 3rd row seats
.
6. Remove the plastic trim from behind rear seats.
7. Remove the spare wheel and the jack.
8. Pull away the weatherstrip, and remove the luggage compartment rear trim.
9. Remove lower trim along RHS interior.
10. Dislodge the
bottom of the RHS ‘B’ Pillar.
11. Remove lower Dash Trim.
12. Dislodge the RHS cargo trim.
13. Remove the RHS upper cargo trim.
14. Fold carpet back to access vehicle grommet.
15. Remove the RHS tail lamp.
Repeat for LHS.
16. Remove the vehicle blanking grommet.
17. Feed the trailer wiring harness from inside to outside the vehicle, starting with the blue
connector.
18. From outside the vehicle, ensure the trailer wiring harness grommet is seated correctly.
19. Route the longer T-Patch along the bottom and up the LHS tail lamp.
20. Connect the tail lamp connector to the trailer wiring mating connector.
21. Repeat for RHS with the shorter T-Patch lead.
22. In the cargo interior, route the Trailer Harness up and across to the exposed cavity on
the RHS.
23. Connect the trailer harness to the ECU (04836) and mount in the location shown.
