Tow bar Fitting Instructions
To Suit Ford Ute AU, BA, BF & FG (TUB BODY) XR6 & XR8 Only
Part Number QTFD962L
Rating 2300 kg Max Static Ball Load 230Kg
Page
2 of 3
Issue Date 3/3/10
THE WORKHORSE OF AUSTRALIA’S TOWBARS
1.
2. Remove spare wheel.
I
NSTRUCTIONS
3. Cut bumper if fitting to either a BA-BF or FG XR series vehicle, as shown in diagrams 2, 3 or 4
respectively.
4. Remove exhaust from three rear most rubber hangers,
5. Fit loose angle mounting brackets to under side of rear cross member using four M10x30 taptite bolts
supplied. Semis tight see tow bar assembly detail for correct component orientation.
6. Lift tow bar into position and fit six M12 x 100 bolts, loose plates through chassis and tow bar loosely.
7. Fit four M10 x 30 bolts to angle mounting brackets loosely.
8. Fit four M10 x 30 taptite bolts through tow bar and into vertical holes in under side of chassis rail.
9. Tighten all taptite bolts to torque listing.
10. Tighten four M10 x 30 bolts to angle mounting bracket to torque listing.
11. Tighten six M12 x 100 bolts to torque listing.
12. Using holes in tail mounting plate as guide drill 11mm hole.
13. Fit tapped plate on wire through larger hole forward of hole drilled, fit bolt and torque to listing.
14. Refit exhaust and spare wheel.
NOTE:
Safety chains may have to be extended, so as not to touch bumper bar.
Diagram-2 Location and size of bumper cut out required when installing the tow bar on a BA XR series vehicle.
Diagram-3 Location and size of bumper cut out required when installing the tow bar on a BF XR series vehicle.
