27
For technical assistance, call 877-722-4097
DESIGNED FOR OFF ROAD USE ONLY
It is against the law to operate on public roads
Read and Follow Safety Instructions
Always wear a helmet
SCOUT 500TX
Troubleshooting
How to add coolant when radiator is empty:
Correctly fill up the coolant and release the air inside.
To fill when completely empty:
As shown in the picture, pull out the small circulating pipe on the temperature adjusting set. Fill the coolant from the intake
of radiator.
Reconnect the pipe when coolant overflows
Continue filling up until the coolant is full. Cap the radiator, Tighten
the hoop of the pipe.
To add additional coolant:
If only a little coolant needed, fill up from the intake of radiator till it is full, and then cap the radiator.
Releasing the air.
If the engine is still overheating when the radiator and water pump is full, and the Temperature Adjusting Set (TAS), fan is
working properly, there may be some air in pipe. To release the air, pull out the small circulating pipe, keep adding coolant
from intake of radiator. Connect back the pipe when the coolant spilled out from the pipe. Then fill up the radiator till it is
full. Cap the radiator and tighten the hoop on the pipe.
Warning! Avoid the risk of serious burns and injury!
Never remove the radiator cap or attempt to remove the intake line when your TrailRover™ is hot.
Pressurized steam and boiling fluid are immediately released from the radiator if the cap is removed while
the engine is hot! Fluid added to a hot radiator will bubble over quickly and may cause severe burns.
Warning!
Improper disposal of coolant is hazardous to the environment and is dangerous to pets and children. Never
release used coolant into ground water supplies. Proper disposal of used coolant is required. Contact your
local authorities for information about proper disposal requirements in your area.
Remove line. Fill the
radiator until coolant
runs from the line.
Securely re-attach the
line to prevent leaking.
Add
Brake
Fluid
Here
Add
Coolant
Here
