traegergrills.com
|
11
INITIAL FIRING INSTRUCTIONS
To be used on initial firing or anytime the grill runs out of pellets.
In order to ensure
proper operation of the grill, you must first prime the auger by allowing the auger tube to be
“charged” with pellets.
1
Remove the porcelain-coated grill
grates, grease drip tray, and the upper
heat shield from the inside of the grill.
2
With the Main Power switch in the
OFF (O) position, attach the power
cord to the grill by plugging it into the
receptacle on the bottom of the hopper.
Then, plug the power cord into an
appropriate grounded electrical outlet.
Once the grill is plugged in, flip the
Main Power switch to ON (
I
).
3
Make sure there are no foreign objects
in the auger. With the grill in Idle
mode, press and hold the UP and
IGNITE buttons simultaneously. The
display will flash “Pri” and the auger
will begin priming
4
Fill the hopper with Traeger Hardwood
Pellets. The auger tube should take
approximately 2 minutes to fill with
pellets and begin dispensing into the
Hot Pot.
WARNING!
Use ONLY TRAEGER
®
BRAND HARDWOOD PELLETS. Never
use heating fuel pellets in the grill.
NOTE: Once you turn on your grill, it will enter Idle mode,
and the display's dashed border will pulse. This indicates
your grill is awaiting a command, and is not actively
operating. The grill MUST be in Idle mode to prime the
auger.
3883 Ironwood_UCG updatev02.indd 11
12/19/17 2:50 PM
