SECTION ONE: ASSEMBLY INSTRUCTIONS
MOUNTING THE LEGS:
1) Carefully lay the Grill on its back on a non-abrasive surface.
Note:
The Hopper /
Burner Assembly (31) will be mounted to the Grill, but is not shown in the diagram
below for clarity.
2) Use the
Black
Bolts, Washers and Nuts (see Detail “A”) supplied in the Hardware Kit
(145) to install the Legs (122) on the left end of the Grill and the Wheel Legs (127)
on the right end as shown in the diagram below. The Acorn Nuts (133) on the Wheel
Legs (127) should go toward the center of the Grill.
Leave the Nuts loose
during
this step.
3) Set the Grill upright to level and then tighten all Nuts.
