Tradinco TRAQC-20 LPC, Руководство пользователя

Страница: 18 / 24

TRAQC-20 LPC
TRAQC-20 LPC 0 13-08-2019 Page: 18
Use
1) Set pressure demand
2) Pressure unit
3) Measured value
4) Actual deviation from the set value
5) Percentage deviation from the set value
6) Elapsed time since start of the Leak function
7) Operating mode
5.5 SETUP settings (SETUP)
General settings
·
Press the MENU button and than press the UP / DOWN until you are on the desired sub menu.
With OK you go into the appropriate sub menu. The following items in the sub menu are available:
·
RANGE: Setting of the measurement range (100% value)
·
UNIT: Selection of the pressure unit (Pa, hPa, kPa, mbar, bar, Torr, mmHG, inHG, psi, mmH20,
inH20)
·
STEPS: Setting of the step size in percent.
·
MODE: Selection of the operating mode
·
CTRL (control): Calibration of pressure sensors and pressure switches
·
MESS (measure): Measurement of differential and absolute pressure
·
AUTO (automatic): Deposit the pressure profiles
·
LANGUAGE: Select language
·
SETTINGS: see below
Sub menu settings
·
ZEROING: On and off the automatic zeroing function (exit the operating menu). Time frequency
of the automatic zeroing.
·
RS232/ USB: Select interface
·
DISPLAY: Brightness setting
·
AUTO: Setting of the range, unit and steps in which the range is divided.
·
STEPS UP/ STEPS DOWN: Various values can be assigned.
·
INFO: Information about the calibrator