Tradesman M3052LW, Руководство пользователя

Страница: 23 / 27

TROUBLESHOOTING GUIDE
CAUTION!
To avoid injury from accidental starting, always turn switch OFF and unplug the tool before moving, replacing the blade or making
adjustments.
Consult your technical support if for any reason the motor will not run.
TROUBLESHOOTING GUIDE - MOTOR
PROBLEM PROBLEM CAUSE SUGGESTED CORRECTIVE ACTION
Brake does not
stop blade within 6
seconds. 1. Motor brushes not sealed
or lightly sticking.
2. Motor brake overheated
from use of defective or
wrong size blade or
rapid ON/OFF cycling.
3. Arbor bolt loose.
4. Other.
1. Inspect / clean / replace brushes. See
MAINTENANCE section.
2. Use a recommended blade.
Let cool down.
3. Retighten arbor bolt.
4. Your Service Center.
Motor does not
start 1. Fuse
2. Brush worn.
3. Other. 1. Use & check 15-Amp time delay fuse, or circuit
breaker.
2. See MAINTENANCE section.
3. Your Service Center.
Excessive brush
spark when switch
released. 1. Fuse
2. Brush worn.
3. Amperage drop 1. Check fuse panel in home
2. Replace Brushes
3. Reduce length of extension cord
TROUBLESHOOTING GUIDE – SAW OPERATION
PROBLEM PROBLEM CAUSE SUGGESTED CORRECTIVE ACTION
Blade hits table. 1. Misalignment.
Blade goes too deep 2. See ADJUSTMENT section.
3. Your Service Center
Angle of cut not
accurate.
Can’t adjust miter. 1. Miter table locked.
2. Sawdust under table. 1. Push positive stop locking lever down and rotate
table.
2.CHECK 90
°
. See OPERATION Section.
3.Vacuum or blow out dust,
WEAR EYE PROTECTION.
Cutting arm
wobbles. 1. Loose pivot points.
1. See ADJUSTMENT Section.
Cutting arm won’t
fully rise, or blade
guard won’t fully
close.
1. Part failure.
2. Pivot spring not replaced
properly after service.
3. Sawdust build-up.
1. Your Service Center.
2. Your Service Center.
3. Clean and lubricate moving parts.
Blade binds, jams,
and burns wood. 1. Improper operation.
2. Dull blade.
3. Improper blade size.
4. Warped blade.
1. See BASIC SAW OPERATION section.
2. Replace or sharpen blade.
3. Replace with 12” diameter blade.
4. Replace blade.
Saw vibrates or
shakes. 1.Saw blade not round.
2.Saw blade damaged.
3.Saw blade loose.
4.Saw blade warped.
1.Replace blade.
2.Replace blade.
3.Tighten arbor bolt.
4.Replace blade.
23