OPERATION
SAFETY INSTRUCTIONS FOR BASIC SAW
OPERATIONS
BEFORE USING THE MITER SAW
CAUTION!
To avoid mistakes that could cause serious, permanent
injury, do not plug the tool in until the following steps are
completed:
Completely assemble and adjust the saw, following the
instructions.
(ASSEMBLY AND ADJUSTMENTS)
Learn the use and function of the ON/OFF switch,
lock-off switch, upper and lower blade guards, stop
latch, bevel lock handle, and cover plate screws.
Review and understand all safety instructions and
operating procedures in this Operator’s Manual.
(SAFETY & OPERATIONS)
Review the MAINTENANCE and
TROUBLESHOOTING GUIDE for your miter saw.
To avoid injury or possible death from electrical shock:
Make sure your fingers do not touch the plug’s metal
prongs when plugging or unplugging your miter saw.
(
ELECTRICAL REQUIREMENTS AND
SAFETY)
BEFORE EACH USE
Inspect your saw.
Disconnect the miter saw.
To avoid injury from
accidental starting, unplug the saw before any
adjustments, including set-up and blade changes.
Compare the direction of rotation arrow
on the
guard to the direction arrow on the blade. The blade
teeth should always point downward at the front of the
saw.
Tighten the arbor bolt.
Tighten the cover plate screw.
Check for damaged parts.
Check for:
Alignment of moving parts
Damaged blade teeth
Damaged electric cords
Binding of moving parts
Mounting holes
Function of arm return spring and lower guard:
Push the cutting arm all the way down, then let it
rise until it stops. The lower guard should fully
close. Follow instructions in
TROUBLESHOOTING GUIDE for adjustment
if necessary.
Other conditions that may affect the way the
miter saw works.
Keep all guards in place, in working order and properly
adjusted.
If any part of this miter saw is missing, bent damaged
or broken in any way, or any electrical parts don’t
work, turn the saw off and unplug it. Replace damaged,
missing, or defective parts before using the saw again.
Maintain tools with care. Keep the miter saw clean for
best and safest performance. Follow instructions for
lubricating. Don’t put lubricants on the blade while it’s
spinning.
Remove all adjusting wrenches from the tool before
turning it on.
USE ONLY RECOMMENDED ACCESSORIES
Consult the ACCESSORIES and ATTACHMENTS
section of this Operator’s Manual for recommended
accessories. Follow the instructions that come with the
accessory. The use of improper accessories may cause
risk of injury to persons.
Choose the correct 12-inch diameter blade for the
material and the type of cutting you plan to do.
Do not
use Thin Kerf blades.
Make sure the blade is sharp, undamaged and properly
aligned. With the saw unplugged, push the cutting arm
all the way down. Manually spin the blade and check
for clearance. Tilt the miter head to a 45° bevel and
repeat the test.
Make sure the blade and arbor collars are clean.
Make sure all clamps and locks are tight and there is
no excessive play in any parts.
KEEP YOUR WORK AREA CLEAN
Cluttered areas and benches invite accidents.
CAUTION!
To avoid burns or other fire damage, never use the miter saw
near flammable liquids, vapors, or gases.
Plan ahead to protect your eyes, hands, face and
ears.
Know your miter saw.
Read and understand the Operator’s Manual and
labels affixed to the tool. Learn its application and
limitations as well as the specific potential hazards
specific to this tool. To avoid injury from accidental
contact with moving parts, don’t do layout, assembly,
or setup work on the miter saw.
Avoid accidental starting
Make sure the switch is OFF before plugging the miter
saw into a power outlet.
15
Содержание M3052LW
Страница 25: ...25...
