8
Follow these steps to mount the antenna to the
mounting surface.
a.
Place the antenna baseplate over the holes
drilled in the mounting surface.
b.
Make sure the four holes in the baseplate line
up with the four holes in the mounting
surface and the antenna’s connectors face the
stern.
c.
At each of the four baseplate mounting holes,
place an M10 lock washer and flat washer on
an M10 bolt and insert the bolt into the hole
from below (see
).
d.
Tighten all four bolts until the four rubber
feet are bottomed against the mounting
surface.
Be sure to use metric (not standard) bolts to
avoid stripping the inserts. To prevent
damage, do not extend the bolts further than
0.4" (10 mm) into the antenna’s baseplate.
IMPORTANT!
Do not block the four small drain holes in the
bottom of the antenna. These drain holes
ensure that any moisture within the antenna
will be able to escape.
IMPORTANT!
Mount the Antenna
Figure 15 Mounting the Antenna (side view)
M10 x 50 mm Bolt (x4)
Antenn
a
B
as
e
Mo
u
nt
Su
rf
a
ce
M10 Fl
a
t W
as
her (x4)
M10 Lock W
as
her (x4)
10 mm m
a
x.
6