TracVision Track Vision M9, Руководство по установке, Страница: 10 / 29

10
Circular/Sky Mexico Version Only
Follow these steps to connect the MCU and one
or two receivers
.
a. Connect the data/power cable from the
antenna to the “Output to Antenna” jack on
the MCU (see Figure 19 ). Do not overtighten
the connection; finger-tight is sufficient.
b. Connect the RF1 cable from the antenna to
the grounding block, as shown in Figure 19 .
Label this grounding block connector “RF1.”
c. If you are connecting two receivers, connect
the RF2 cable from the antenna to the
grounding block, as shown in Figure 19 .
Label this grounding block connector “RF2.”
d. Attach the supplied ground wire to either
ground screw on the grounding block.
Connect the other end of the wire to a
suitable vessel AC ground.
e. Using the two supplied #6 screws, mount the
grounding block inside the vessel.
f. Connect an RF cable from the “RF1”
connector on the grounding block to the
“Satellite In” connector on the primary
receiver. The primary receiver controls
satellite selection if the antenna is set up for
automatic switching.
g. If you are connecting two receivers, connect
an RF cable from the “RF2” connector on the
grounding block to the “Satellite In”
connector on the secondary receiver.
h. Connect the receiver(s) to the customer’s
television(s). Follow the instructions in the
receiver’s manual.
If you wish to connect three or more receivers
to the antenna, see Appendix B on page 25 .
IMPORTANT!
Wire the Receiver(s) and MCU
Figure 19 Wiring Diagram - Circular/Sky Mexico Version
RF1
MCU
OUTPUT TO
ANTENNA
MAINTENANCE PORT RF PORT
POWER IN
+24 VDC
Vessel Power
Power In
Output to
Antenna
Antenna
RF2
Secondary Receiver
(optional)
SATELLITE IN
S-VIDEO
DIGITAL AUDIO
OUTPUT
R AUDIO VIDEO
USB ETHERNET
L
Pr Pb Y
Satellite In
SATELLITE IN
S-VIDEO
DIGITAL AUDIO
OUTPUT
R AUDIO VIDEO
USB ETHERNET
L
Pr Pb Y
Satellite In
Vessel
AC Ground
Grounding
Block
RF1
RF2
RF1
RF2
Data/
Power
Primary Receiver
8