TracVision R6ST, Руководство по установке

Страница: 9 / 11

10
a. If you wish to mount the receiver, attach
the two mounting brackets to the sides of
the unit using three #2-56 screws. Simply
screw these fasteners into the vent slots
(see Figure 16 ).
b. If you are using the mounting brackets,
secure the brackets to the mounting
surface using appropriate 1/4" fasteners
(not supplied).
NOTE: Be sure to leave enough slack in the
connecting cables (service loop) for easy
serviceability.
c. Place the RF converter at least 3 feet away
from the receiver. If it is too close to the
receiver, the remote control might not
operate properly. Also avoid placing the
RF converter behind a metal surface or in
an area surrounded by metal.
d. If desired, mount the RF converter using
the supplied Velcro fasteners.
e. Insert two AAA batteries (supplied in the
kit) in the remote control’s battery
compartment (see Figure 18 ).
To avoid overheating, do not block
the upper vents of the receiver.
IMPORTANT!
Mount the Receiver 8
Figure 16 Receiver Brackets
Figure 17 RF Converter
Figure 18 Remote Batteries
Bracket
#2-56 x 1⁄4"
Screws (x3)
1⁄4" Fasteners (x4)
(not supplied)
AAA Batteries