1. Turn off the power switch on the rear panel of the
original TracVision A5/M3 12V receiver. The
switch’s green light should go out.
2. At the rear panel of the original receiver,
disconnect the RF cable from the “Satellite In”
jack. Leave the cable connected to the “To Satellite
In” jack.
3. Connect the RF cable (that you disconnected in
Step 2) to the splitter’s “Input” jack.
4. Connect the 7" RG179 RF cable from either of the
splitter’s “Out” jacks to the “Satellite In” jack on
the original receiver.
5. At the second receiver’s rear panel, completely
remove the short RF cable from the “Satellite In”
and “To Satellite In” jacks. Discard this cable. Also
remove this cable from the third receiver, if
applicable.
6.
If you are connecting only one additional
receiver
, connect the 6-ft. RG179 RF cable from the
splitter’s other “Out” jack to the second receiver’s
“Satellite In” jack.
You can use a longer RF cable, if
desired.
Skip to Step 8.
7.
If you are connecting two additional receivers
,
connect the 6-ft. RG179 RF cable from the splitter’s
other “Out” jack to the second splitter’s “Input”
jack. Then connect RF cables from the splitter’s
two “Out” jacks to the “Satellite In” jacks on the
two additional receivers.
You can use longer RF
cables, if desired.
8. Follow the instructions in the
Installation Guide
to
connect the RF converter, audio/video cables, and
power wires to the second receiver and third
receiver, if applicable.
9. Follow the instructions in the
Installation Guide
to
mount the second or third receiver, if desired.
10. Install two AAA batteries in the new remote control(s).
54-0221 Rev. F
4
TracVision A5/M3
POWER
VEHICLE POWER
(10-16 VDC)
VHF ANTENNA
IN
AUDIO R
AUDIO L
VIDEO
S – VIDEO
PHONE JACK
RF
REMOTE
INPUT
OUT TO TV
TUNER
SATELLITE IN
C AU T I O N
This device complies with Part 15 of the FCC rules. Operation is subject
to the following two conditions: (1) This device must not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
Tested to comply
with FCC Standards
TO SATELLITE
IN
TO KVH
ANTENNA
DIAGNOSTICS
PORT 1
DIAGNOSTICS
PORT 2
Power Switch
Disconnect Here
Original TracVision A5/M3 12V Receiver
