Steps for installing the MAC
1.
Using the supplied 1/2-inch drill bit, drill holes for mounting the u-bolts. Carefully
choose your ROPS size on the drilling template located on top of the console.
Caution!
Drilling holes improperly will void the factory warranty.
2. Insert the 4 grommets into the drilled holes. Lubricate the grommet holes for the u-
bolts. Mount the u-bolts onto the top of the ROPS.
3.
With the speakers removed, lift the ABS console housing in place under the ROPS
and insert the u-bolts ends through the rubber grommets.
4.
In order, insert the rubber pad, backing plate and nut onto the u-bolt ends inside the
console speaker holes. Tighten evenly to prevent the housing from distorting.
5.
Re-attach the speaker and wires to the ABS console housing.
6. Using the supplied sticky back wire tie mounts, fasten the wiring harness to the inside
of the ROPS and along the chassis of the tractor, being careful to keep away from any
moving parts. (Make sure to provide enough slack for pivoting the ROPS.)
7. There are two wiring options for your MAC Audio Console.
(next page)
