Chapter 2: Getting started
18
Getting started with the wireless IP Handset
Charging the IP Handset
Introduction
The battery icon next to the handset icon
in the top right corner of the display
shows the battery status of the handset.
When the battery level is critically low,
the handset makes a sound and shows a message, and the icon starts flashing
to indicate that the battery needs recharging. If the battery is not recharged,
the handset will eventually switch off.
There are two options for charging the handset:
•
To charge the IP Handset using the cradle
•
To charge the IP Handset from a computer or USB charger
(only wireless
model)
On delivery the battery of the IP Handset is approximately 50% charged and
ready for use.
To charge the IP Handset using the cradle
The cradle must be connected to an external 10-32 V DC power supply, as
described in the previous section.
Place the IP Handset in the cradle with the display facing up. The handset
automatically starts the charging process.
To charge the IP Handset from a computer or USB charger
You need a computer or a USB charger and a USB cable with a mini-USB 5-pin
connector at one end and a USB-A connector at the other end.
Do as follows:
1. Connect the mini-USB connector to the connector at the side of your
handset.
Содержание FleetBroadband
