8
CAUTION!!!!
SPINNING BLADE
Operation
The Model 858 Trac-Vac is designed to operate at a 540 RPM PTO speed. Poor performance will
result if ran much below recommended speed.
1.
Inspect area to be vacuumed and pick up all harmful objects and litter. Rocks and other
harmful debris can do serious damage to vacuum assembly and cause bodily injury.
2.
For best vacuuming results operate tractor at manufacturers’ recommended speed for best
cutting. If grass is high, reduce ground speed to prevent overloading mower and vacuum.
If grass is wet, wait until dry for best results.
3.
When mowing, keep discharge chute to the outside of the cutting area for better cut of
grass and efficient pickup of grass clippings and leaves.
4.
Do not overload cart. When it is filled shut off vacuum, disconnect hose at snap
disconnect, remove tailgate and dump.
5.
When operating tractor on slope or grade, exercise much caution. Do not cut across grade
or slope. Mow directly up or down hill.
6.
Periodically tighten all bolts.
7.
Listen for unusual vibration of air turbine. If excessive vibration is present,
STOP
vacuum and check for damaged blade.
8.
Always shut off tractor engine before servicing vacuum.
9.
Replace deflector shield when discharge chute is removed.
10.
When removing clogs,
SHUT OFF ALL
engines.
Maintenance
•
Your 858 Trac-Vac has been serviced at the factory for initial operation.
•
Bearings should be greased and gearbox oil checked. Gearbox oil level should be to the bottom of
the cross shaft bearing. Overfilling will cause oil to be forced out though the vent. Fill with 90
weight gear lube.
•
Check belt tension after the first hour of operation and every ten hours thereafter.
•
Adjust inboard belt first by moving jack shaft bearing to the rear, then adjust outboard belt by
moving gearbox forward.
TRAC VAC WARRANTY POLICY
Midwest Equipment Mfg. will repair or replace, free of charge, any part, or parts that are
defective in material or workmanship or both for a period of one year residential use, and 90
day’s for commercial and rental use. The purchaser will pay transportation charges on parts
submitted for replacement under warranty. For warranty service, contact your local dealer from
whom the unit was purchased. There are no other express or implied warranties. Some states do
not allow limitations on how long an implied warranty lasts, and some states do not allow the
exclusion or limitation of incidental or consequential damages, so the above limitation and
exclusion may not apply to you. This warranty gives you specific legal rights and you may also
have other rights, which vary from state to state.
MIDWEST EQUIPMENT MFG.
5225 Serum Plant Rd.,Thorntown, IN 46071
Phone: 1-800-Trac-Vac