REPLACE MOTOR AND/OR GEARBOX
If the a motor should go bad for some reason, all you have to do is to unplug the curly
cord from the back of the joystick, unplug the wiring harness from the motor and brake
at the back of the control module. Remove the four bolts at the gear box and lift the motor
out. Remove the drive part from the motor shaft, taking note how it is installed. If the
wiring is removed from the motor, it is a good idea to mark the motor wires before
disconnecting. This will help connecting the motor to turn the right way on installation.
To remove the gearbox, block the machine up off the tracks, remove the track, remove
the rear drive wheel, remove the four bolts that hold the gearbox to the gearbox mount on
the frame.
This information is for a service center only.
CLEANING AND WASHING
When washing the IRV2000, be very careful not to spray high pressure water into the
back of the machine. Under the cover that the seat sets on is all of the electronics. If you
have been operating near salt water, remove the battery cover and flush the deck
completely. Wash all sand and salt water from the wheels, and lubricate the drive pin
with a light household oil. The material cover of the seat can often be cleaned by using
warm water and a mild soap. Be sure you rinse the material to remove any soap.
Page 13
03-29-02
